Abstract
A leeward sawtooth roof building has an inlet opening in the lower level of the windward facade and an upper-level outlet opening near the roof top, in the leeward facade. Leeward sawtooth roof buildings can be applied to efficiently ventilate low-rise buildings. Previous studies of the authors showed that the ventilation potential strongly depends on the roof inclination angle and roof geometry. The current study focuses on the ventilation flow in single-zone elongated low-rise buildings with a single-span versus double-span leeward sawtooth roof and different opening ratios. Straight, concave and convex roof geometries are evaluated. The analysis is performed using 3D steady Reynolds-averaged Navier-Stokes Computational Fluid Dynamics (CFD) simulations with the SST k-ω turbulence model. The computational grid is based on a grid-sensitivity analysis and the simulation results are validated based on Particle Image Velocimetry (PIV) measurements from literature. For the single-span cases, the convex roof results in the highest volume flow rate, which is about 8.8% higher than for the concave roof, and 3.5% higher than the straight roof. A double-span roof performs slightly better than a single-span roof with respect to ventilation flow rates (below 4.2%) in case of a straight or concave roof, but worse in case of a convex roof (-12%). The internal roof geometry near the outlet opening plays an important role in the ventilation of the building. Finally, the inlet-to-outlet opening ratio has an important effect on the volume flow rates, with significantly higher ventilation flow rates for a lower opening ratio.
Original language | English |
---|---|
Pages (from-to) | 142-156 |
Number of pages | 15 |
Journal | Building and Environment |
Volume | 96 |
DOIs | |
Publication status | Published - 1 Feb 2016 |
Keywords
- Computational fluid dynamics (CFD)
- Double-span leeward sawtooth roof building
- Leeward sawtooth roof geometry
- Natural ventilation
- Upward cross-ventilation
- Urban physics
ASJC Scopus subject areas
- Environmental Engineering
- Civil and Structural Engineering
- Geography, Planning and Development
- Building and Construction