Cavitation Erosion in HVOF Thermally Sprayed WC-NiCrBSi Coatings

Cavitation is a wear process in engineering systems caused by the energy release of collapsing bubbles leading to the failure of critical components such as valves, pumps, and propellers. Thermally sprayed coatings can be applied to improve the wear resistance of these components. This investigation considers a WC-NiCrBSi coating composition under cavitation wear, where the WC phase provides the strength and the NiCrBSi matrix offers corrosion resistance in seawater. Coatings were deposited on AISI 440C stainless steel discs of 32mm diameter and 8mm thickness using industrially optimized parameters for the HVOF JP5000 system. Indirect cavitation tests were conducted using a modified ASTM G32 testing procedure on coated test coupons in as-sprayed and Hot Isostatic Pressed (HIPed) conditions. Two tests were performed for each coating using natural seawater of pH 8.19 at room temperature, and averaged wear values are reported to compare the cavitation rate and cumulative mass loss of the coatings. Coating microstructural phases in the as-sprayed and HIPed conditions were identified using X-ray diffraction. The microstructure of the coating substrate system and post-cavitation test wear scars were investigated using Scanning Electron Microscopy (SEM) equipped with energy dispersive spectroscopy (EDS). This investigation provides an understanding of the corrosive-cavitation wear behavior and failure modes of coatings. The cavitation erosion rate and cumulative mass loss results showed that the as-sprayed WC-NiCrBSi coatings improve the cavitation wear resistance of the substrate.